Discontinued: Lemon Rx Microbrick DSMX / DSM2 Compatible Receiver with Molex 1.25 Connector (LM007M1)

Product Discontinued.

The Lemon Microbrick combines a full-range DSMXTM/DSM2TM compatible receiver with two onboard ultramicro servos and a 5A brushed speed controller in a package that weighs under 7g. It has connectors for two external servos and can also support a separate brushless ESC. Finally, it provides optional three-axis stabilisation. It is an ideal solution for models up to about 250g, including many light weight UMX type planes. It can run off a 1s or 2s LiPo, recommended 150-220mAh size cells.

The Microbrick can be used with almost any DSMXTM/DSM2TM compatible transmitter.

The Microbrick has five available flight channels in standard Spektrum order (1-4, 6), plus two internal control channels:

Channel 1: Throttle: Onboard 5A brushed throttle and external signal for a brushless ESC
Channel 2: Aileron (or Right Aileron in dual servo aileron setups; optionally the onboard Rudder servo for 3 channels where Aileron stick is used for the Rudder)
Channel 3: Elevator onboard servo
Channel 4: Rudder onboard servo
Channel 5: On/Off control of stabiliser (internal to the receiver)
Channel 6: Aux1 (or Left Aileron in dual servo aileron setups)
Channel 8: Master gain control of stabiliser sensitivity (internal to the receiver)

Feature

• DSMP protocol (fully compatible with DSMX / DSM2)
• Integrated 5A brushed motor driver
• Optional external brushless ESC connection
• Gyro stabilizstion on/off via gear channel
• Delta, fixed wing and V-tail mixing
• Legacy mode for single control stick operates both elevator and rudder channel
• Dual aileron for fixed wing
• Remote gain control on AUX3 (for transmitter with 8-channel or up)
• Servo swap feature (rudder and elevator servo position exchangeable for flexible installation)
• Intended for 1S LiPo application. 2S LiPo (8.4V) operational with dual on-board servo. (Note that the external servo over JST 1.0mm connection may not be able to work at 8.4V)
• Exceptional holding torque with approximately 0.10kg*10mm with 4.2V and 0.13kg * 10mm with 8.2V.

Versions (the difference is the choice of power / motor connetor):

• LM0070H – 2.54MM Header Pins
• LM0070M1 – Molex 1.25 Connector

Note: This is not a Spektrum product, nor is it a copy of any Spektrum product. Lemon RX develops its own technology to produce receivers which are fully DSM2 / DSMX compatible. Spketrum, DSMX and DSM2 are the registered trademark of Horizon Hobby, Inc.