Holybro Atlatl HV 5.8G 3W Pro VTx FPV Video Transmitter

Legal Notice: Please check with your local authorities regarding the operation of this equipment before you purchase. Regulations on power output, usable frequencies and licenses’ to operate vary from region to region. By adding this product to your cart, you are confirming that you have read this notice, and that Flying Tech is in no way responsible for the actions of the operator while using this product.

Holybro’s latest Atlatl VTX – updated with two button for easier setup and clear LED indicators.

This video transmitter offers a variable power supply, from 25mW (UK legal limit) up to 3W. Running at 3W generates a lot heat, so the VTX incorporates a built-in fan. It also has Pit Mode so that you can power up your VTX to change settings without knocking other pilots out of the air. There is also IRC Tramp which allows you to control your VTX via your flight controller to change channel and transmitting power remotely from your RC. The Atlatl Pro VTX comes with a durable MMCX connector and also with a pigtail SMA converter.

WARNING: MAKE SURE TO INSTALL ANTENNA BEFORE TURNING ON THIS VIDEO TRANSMITTER

Indicator Light Description

• Power light (Green)
  • Blink once per sequence – 25mW
  • 2 per sequence – 400mW
  • 3 per sequence – 600mW
  • 4 per sequence – 1.6W
  • 5 per sequence – 3W
• Frequency indicator light (Blue)
  • Binary indicator. No lights means CH1, all lights means CH7
• Frequency band lights (Red)
  • Blink once per sequence – Band A
  • 2 per sequence – Band B
  • 3 per sequence – Band E
  • 4 per sequence – Band F
  • 5 per sequence – Band R
  • 6 per sequence – Band L
  • 7 per sequence – Band X

Function Button Operation Instructions

• To switch frequency – Short press the button to switch channel.
• To switch the frequency band – Press and hold the button for 2 seconds to enter band changing mode. Short press the button to change the frequency band once enter the band changing mode.
• To switch power – Short press the button to switch the power level. Green LED blinking times for each blinking sequence indicate the power level. Long press 2 seconds to enable PIT mode – green light stays on.
• Once the configuration is finished, wait 8 seconds for it to save the settings.

Frequency Table