Strobon V2 Navigation Strobe Lights​

We rated the Strobon V1s as the best strobe lights on the market and now they have got even better. V2 Strobons are smaller, lighter and now support 5 different working pattern, including ‘blink’, ‘heartbeat’, ‘rotating beacon’, ‘static’ and of course the legendary ‘strobe’. As with the V1s, if you use more than one Strobon on the same servo channel they will synchronise, meaning all strobes will flash at the same time like a real aircraft strobe system. You can also switch them on and off remotely. The Strobons are available in five colours white, red, green, blue and yellow. We also sell a covert Infrared (IR) 940nm version – Visible for Night Vision Goggles only. Completely invisible to the naked human eye. Some cameras can see in the short-range.

The Strobon V2 is available to buy unsoldered or pre-soldered with a 30CM servo lead. Please select as required.

Warning, these lights are seriously bright, we wouldn’t recommend looking directly at them close-up, they are blinding!

This product is compatible with latest FAA and CAA anti collision lights rules for drones. It’s visible from 3 miles away at night.

If you would prefer a zero wiring option, there is now the new Strobon Standalone Strobe LED which is battery powered.

5 different patterns:

• Strobe: Legendary Strobon v1 strobe effect. 3 fast flashes like xenon wing tip flash lights.
• Blink: Simulates belly or tail lights. Continuous ON/OFF.
• Heartbeat: Standard beacon light pattern, ramp up/ramp down/off.
• Rotating Beacon: Perfect simulation of rolling beacons. ramp up/flash/ramp down/off.
• Static: You can use it as landing headlights or static wing-tip lights.

2 different working modes:

The device features 2 different working modes, continuous or RC mode.

• RC Controlled Mode: Plug it on your RC receiver’s any channel for RC mode, then you can enable/disable it over selected servo channel.
  Each Strobon counts the servo signals. So, you can plug more than one Strobon to the same RC channel to synchronise them.
• Standalone Mode: Power it with directly from the battery (3.5-6v) it works on Standalone mode and works continuously.

Optional Accessory: If you are wanting to run multiple strobes and have them synchronised without using a radio receiver, we recommend getting the PWR 3A Strobon Navigation Light Synchroniser with a built-in power supply. The synchroniser generates a PWM signal to supply and synchronise the navigation lights while also providing a regulated 5V power supply to them.

Pattern Selection:

To set the pattern, all you need is a piece of wire or some tweezer to use to connect the two small pads of the strobon v2 board while it’s working (it will not change the pattern when it’s OFF). It will stop working when you connect these pins and jump to next pattern when you release the connection. The strobons have a memory, so the slected pattern is remembered even if you disconnect the power.

A polycarbonate lens is now available to mount the Strobon V2 LEDS.

15° to 100° Clear Lenses – Here