COVID-19 Update: Flying Tech is open and shipping daily, however our phone support is limited so please email us if possible. Please note shipment times may take longer than normal as postal services are operating with fewer staff.
Thanks to all of our customers for their support at this difficult time and stay safe.
The Matek HUBOSD eco X-Type PCB is a multifunctional HUB with 4 channel PDB, dual BECs, a current sensor and a plug and play integrated OSD.
The PDB can provide power up to four ESCs rated at 30A per channel and compatible with 3 to 5S LiPo batteries. The BEC outputs provide 5volts at 2A and 12volts at 0.5A. The 5V BEC connection is ideal for powering your flight controller or RC receiver. The 12v BEC is a linear type regulator so no LC filter is needed to clean up the power supply if used for a 12V FPV camera.
The Matek HUBOSD8-SE is a fully featured well designed PDB for FPV racing drones. It is a multifunctional HUB with 4 channel PDB, dual BECs, a current sensor and a plug and play integrated OSD.
The PDB can provide power up to four ESCs rated at 30A per channel and compatible with 3 to 6S LiPo batteries. The BEC outputs provide 5volts at 1.5A and 10volts at 1.5A, while the built-in current sensor measures up to 184A. Note that the 10V output can be used to power 12V cameras.
Here's another 5V piezo buzzer, but this one is different from the rest in that it's compatible with both PWM receivers and with most racing drone flight controllers. When used with a flight controller, it can be setup as a low voltage alarm, lost model alarm and it can also be configured to provide status alerts like 'no rx signal' and other warnings*. If you use it with a traditional PWM receiver, simply connect it an auxiliary channel and activate it with a switch on your transmitter.
The Matek 3-In-1 Battery Monitor, Signal Loss and Lost Airplane Alarm is a handy little device that will help protect your valuable investment. First, it acts as a battery voltage monitor. Once voltage gets below the threshold you set, the alarms will go off and a red LED will illuminate. Additionally it can detect if signal is lost to your receiver, and just like the voltage monitoring feature, the alarms will go off. The last feature is the lost model alarm which operates when plugged into an auxiliary channel on your receiver, such as the retract switch.
- Dual modes: MCU control (Standalone) or Cleanflight control (Programmable)
- 8x Super Bright 5050 WS2812B RGB LEDs
- Perfect racing drone tail light
- 7 colors: White, Green, Red, Blue, Yellow, Cyan, Magenta
- Four LED states: Constant light, Slow flash, Fast flash, Violent flash
|Quantity||1||2 - 4||5 - 99|
We like all of Matek's racing drone PDBs, but this has to be our favourite. It comes with an integrated XT60 power connection which not only looks the part, it stops your power cables from getting caught up in the props. We've also found it to be easy to solder and most importantly reliable.
LEDs look great at night and they can be useful to help with orientation even in the daytime. LEDs also come in handy for FPV miniquad racing. Racing drones are actually quite hard to see on FPV video, especially if you are racing at full speed through a field of trees. Using LEDs is one solution to the problem. Fix a few to your drone and it will make it much easier for your mates to follow you.
This has to be the ultimate power distribution board (PDB) for any mini quad. It's much more than just a simple PDB, it's better described as a power hub. It has both 5v and 12v regulated BECs, a LED light controller and even lost plane finder & low voltage alarm functions.